NXP LPC1768 Development Kit

The LPC1768 Development Kit contains all of the hardware and software required for evaluating and developing with NXP's LPC1700 series microcontrollers. The kit consists of the RDB1768V2 Development board, a fully featured evaluation version of Red Suite, and a suite of example programs. The integrated on-board debug circuit, means that no additional debug probe is needed when used with Red Suite. 

With the NEW Drag2FLASH feature, the board appears to the host as a Flash drive. Drag a built binary to the drive, and press a button to run!

ADV DEV KIT - NXP LPC1700 family Microcontrollers - Datasheet                                     

                  NXP LPC210X Starter Kit

The NXP LPC210X Starter Kit provides a complete environment in which you can develop your programs for the NXP LPC210X family of microcontrollers and even drive a legacy 8051 board.

• • Full support for Philips ISP flash programming software
  • 32 leds – one for each port pin
  • 20-pin JTAG connector with jumpers allowing it to be configured for either LPC2101/2/3 or LPC2104/5/6 chips.
  • Clam-shell socket allowing the LPC2103 to be readily replaced with an LPC2101/2/4/5/6 chip
• A serial cable to connect a PC to the SE-ARM-P
• A power supply and mains cable
• A 32k byte evaluation version of the Crossware ARM Development Suite which includes an ANSI C compiler, Assembler, Simulator/Virtual Workshop, Debugger, Code Creation Wizards, Embedded Development Studio IDE and on-line manuals
• A header cable that allows the SE-ARM-P to be connected to a 40-pin DIL 8051 socket allowing you to run your 8051 board with an ARM chip.
• A printed Getting Started guide

The Crossware Jaguar USB JTAG debugger interface is optionally available to provide fast download and full source level debugging.

Use this link to download the NXP LPC2000 Flash Utility:

http://www.standardics.philips.com/support/techdocs/microcontrollers/zip/flash.isp.utility.lpc2000.zip

    ATMEL Flash Microcontroller Starter Kit

ATMEL Flash Microcontroller Starter Kit provides a complete environment in which you can develop your 8051 programs.

It includes:

• An SE-8051ICD board fitted with an Atmel AT89C51ED2 flash microcontroller
• A header cable that allows the SE-8051ICD to be used as an in-circuit debugger
• A serial cable to connect a PC to the SE-8051ICD
• A power supply and mains cable
• A 4k byte evaluation version of the Crossware 8051 Development Suite which includes an ANSI C compiler, Assembler, Simulator/Virtual Workshop, Debugger, Code Creation Wizards, Embedded Development Studio IDE and on-line manuals
• Atmel's Flexible In-System Programming system (FLIP)
• A printed Getting Started guide
•  

90% of the customers who have purchased this kit have come back and purchased additional kits. It is a very useful and flexible piece of equipment.          

 ATMEL Flash Microcontroller Starter Kit – Guide